Part of your test includes a 'Show me, Tell Me' section. This is when your examiner will ask you one 'Show me' and one 'Tell me' question about general maintenance and safety checks on your car.
You can get an idea of the questions you will be asked on
this page and by clicking each of these ,
you can see see an example of the response
you would give.
A wrong answer to one, or both of the questions counts as one Minor Fault.
Brakes
should be tested as you set off by applying gentle pressure at slow
speed. Brakes should not feel spongy or slack and the vehicle should
not pull to one side.
In
the manufacturer’s guide, use a reliable pressure gauge, check and adjust
pressures when tyres are cold, don’t forget spare tyre, remember to refit
valve caps.
Tyres
should be checked to ensure there are no cuts or bulges. There should be 1.6mm
of tread depth across the central ¾ of
the breadth of the tyre and around the entire outer circumference. This can
be checked with a tyre depth guage or the depth markers in the tyres themselves.
If
the steering becomes heavy the system may not be working properly. Before starting
a journey two simple checks can be made. Gentle pressure on the steering wheel,
maintained while the engine is started, should result in a slight but noticeable
movement as the system begins to operate. Alternatively turning the steering
wheel just after moving off will give an immediate indication that the power
assistance is functioning.
Apply
footbrake firmly, Demonstrate by applying parking brake so that when it is
fully applied it secures itself, and is not at the end of the working travel.
Applying
the indicators or hazard warning switch and check functioning of all indicators.
You may need to switch the ignition on, however you should not start the
engine.
Operate
brake pedal, make use of reflections in windows, garage doors, etc, or ask
someone to help. As this is now a show me question the examiner may check
the brake lights for you. You may need to switch the ignition on, however
you should not start the engine.
Set
all relevant controls including; fan, temperature, air direction / source
and heated screen to clear windscreen and windows. Engine does not have to
be started for this demonstration
Operate
the rear fog switch after switching on dipped headlights check switch is
illuminated and explain that they should only be used when visibility is
reduced to 100 metres or less
Brakes
should be tested as you set off by applying gentle pressure at slow
speed. Brakes should not feel spongy or slack and the vehicle should
not pull to one side. 
In
the manufacturer’s guide, use a reliable pressure gauge, check and adjust
pressures when tyres are cold, don’t forget spare tyre, remember to refit
valve caps. 
Tyres
should be checked to ensure there are no cuts or bulges. There should be 1.6mm
of tread depth across the central ¾ of
the breadth of the tyre and around the entire outer circumference. This can
be checked with a tyre depth guage or the depth markers in the tyres themselves. 
Adjust
the rigid part of the restraint so that it is close to the back of your head
and level with your eyes or top of your ears
Operate
light switch (turn on ignition if necessary).
The
ABS warning light would become illuminated on the instrument panel if there
is a fault
Identify
dipstick / oil level indicator, describe check of oil level against the minimum/maximum
markers. 
Identify
reservoir, check fluid level is between high / low markings. 
Identify
high / low level markings on header tank where
fitted or radiator filler cap, and describe
how to top up to correct level. 
Identify
reservoir and explain how the washer fluid should be filled to a
level between the min and max markers on the side of the reservoir 
If
the steering becomes heavy the system may not be working properly. Before starting
a journey two simple checks can be made. Gentle pressure on the steering wheel,
maintained while the engine is started, should result in a slight but noticeable
movement as the system begins to operate. Alternatively turning the steering
wheel just after moving off will give an immediate indication that the power
assistance is functioning. 
Apply
footbrake firmly, Demonstrate by applying parking brake so that when it is
fully applied it secures itself, and is not at the end of the working travel. 
Check
is carried out by pressing gently on the control (turn on ignition if necessary)
Operate
brake pedal, make use of reflections in windows, garage doors, etc, or ask
someone to help. As this is now a show me question the examiner may check
the brake lights for you. You may need to switch the ignition on, however
you should not start the engine.
Operate
control to wash and wipe windscreen. You may need to switch the ignition
on, however you should not start the engine. 
Set
all relevant controls including; fan, temperature, air direction / source
and heated screen to clear windscreen and windows. Engine does not have to
be started for this demonstration
Operate
the rear fog switch after switching on dipped headlights check switch is
illuminated and explain that they should only be used when visibility is
reduced to 100 metres or less
Move
the stalk attached to the steering column forwards which will illuminate
a blue warning light on the instrument panel